OpenBCM V1.07b12 (Linux)

Packet Radio Mailbox

IW8PGT

[Mendicino(CS)-Italy]

 Login: GUEST





  
KO4T   > TECH     09.02.24 13:47l 9 Lines 1589 Bytes #999 (0) @ WW
BID : 9759_W4BFB
Read: GUEST
Subj: DECODING JS1YMG: FIRST HAM RADIO STATION ON THE MOON
Path: IW8PGT<IZ3LSV<I0OJJ<N6RME<CX2SA<AC4ZR<WB4QOJ<W4BFB
Sent: 240209/1235Z 9759@W4BFB.#CLT.NC.USA.NOAM BPQ6.0.24

When Japanâ€Ös SLIM lunar lander made a rather unconventional touch-down on the lunar surface, it had already disgorged two small lunar excursion vehicles from its innards: LEV-1 and LEV-2. Of these, the LEV-1 is not only capable of direct to Earth transmission, but it also has been assigned its own amateur radio license: JS1YMG, which makes it the first Ham radio station on the Moon. LEV-1 receives data from LEV-2, which is transmitted to Earth using its 1 Watt UHF circular polarization antenna as Morse code at 437.410 MHz. Although the data format hasnâ€Öt been published, [Daniel Estévez] (EA4GPZ) has been sleuthing around to figure it out.

Using captures from the 25 meter radiotelescope at Dwingeloo in the Netherlands, [Daniel] set to work deciphering what he knew to be telemetry data following a CCSDS standard. After some mix-and-matching he found that the encoding matched PCM/PSK/PM with a symbol rate of 64 baud and 2048 kHz subcarrier. The residual carrier is modulated in amplitude with Morse code, but initially this Morse code made no sense.


Waterfall of the LEV-1 signal (Credit: Daniel Estévez)
Waterfall of the LEV-1 signal (Credit: Daniel Estévez)
Fortunately a few fellow Hams pitched in and figured out that the amplitude signs for the Morse code were inverted. By inverting the amplitude, suddenly the Morse code looked a lot more clear, with the LEV-1â€Ös call sign and what looked like hexadecimal data following it. Each of the frames is also followed by a CRC-16, which should make it possible to start decoding the data transmitted in each frame.


Read previous mail | Read next mail


 23.12.2024 03:38:28lGo back Go up