| |
G8MNY > TECHNI 01.10.18 07:56l 132 Lines 5041 Bytes #999 (0) @ WW
BID : 40192_GB7CIP
Read: GUEST
Subj: Adjusting 78xx/79xx Regulators
Path: IW8PGT<IR2UBX<DB0RES<DB0ERF<OK0NAG<OK0PBR<OK2PEN<N3HYM<GB7CIP
Sent: 181001/0644Z @:GB7CIP.#32.GBR.EURO #:40192 [Caterham Surrey GBR]
From: G8MNY@GB7CIP.#32.GBR.EURO
To : TECH@WW
By G8MNY (Updated Feb 05)
(8 Bit ASCII graphics use code page 437 or 850, Terminal Font)
There are 3 way to simply increase the regulator voltage.
1/ Add a series zener or diodes or a mixture in the common leg. Most makes of
regulator put about 50uA down the common leg, this may affect the zener/diode
drop. A pull up R of a few kê from the zener to the output could be needed with
slightly leaky zeners/diode to get the desired drop.
in ÚÄÄÄÄÄÄÄ¿out
+12V >ÄÄÄÄÄÄÂÄÄÄÄ´ 7805 ÃÄÄÄÄÄÂÄÄÄ> +8V
RAW DC ³ ÀÄÄÄÂÄÄÄÙ ³
FROM >2200uF ³+ comÃ Ä ÄRÄ Ä ´
BRIDGE 16V === _³_ ³
RECTIFIER ³ /_\` 3V === 0.1u
& 10V AC ³ ³ ³
0V >ÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÄÁÄÄÄ>
Thermal stability fair, as it is dependent on Reg + Zener, 3 Ä 5V zeners
generally have the best stability!
in ÚÄÄÄÄÄÄÄ¿out
+12V >ÄÄÄÄÄÂÄÄÄÄ´ 7805 ÃÄÄÄÄÄÂÄÄÄ> +5.5V
RAW DC ³ ÀÄÄÄÂÄÄÄÙ ³
FROM ³ com³ ³
BRIDGE >2200uF ³+ _³_ ³
RECTIFIER 16V === \_/ 0.5V === 0.1u
& 8V AC ³ ³ ³
0V >ÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÄÁÄÄÄ>
If the diode is an LED, the voltage increase could be 1 Ä 1.5V depending on the
colour & current fed through it.
Thermal stability poor, as it is dependent on Reg + diode, the diode drop will
alter quite a lot hot to cold.
in ÚÄÄÄÄÄÄÄ¿out
+24V >ÄÄÄÄÄÂÄÄÄÄÄÄÄÄÄ´ 7805 ÃÄÄÄÄÂÄÄÄ> +15.5V BOOST
³ ÀÄÄÄÂÄÄÄÙ ³ +15.0V NORMAL
RAW DC >2200uF³+ com_³_ ³
FROM 30V === /_\' ³
BRIDGE ³ NORMAL____³ 10V === 0.1u
RECTIFIER ³ BOOST O _³_ ³
& 17V AC ³ \o \_/ 0.5V ³
0V >ÄÄÄÄÄÁÄÄÄÄÄÄÄÄÁÄÄÄÄÁÄÄÄÄÄÄÄÄÁÄÄÄ>
Thermal stability poor as it is dependent on Reg + Zener + diodes,
2/ Add a series R in the common leg. Most makes of regulator put about 50uA
constant current down the common leg, so a small R can uplift the voltage.
in ÚÄÄÄÄÄÄÄ¿out
+22V >ÄÄÄÂÄÄÄÄÄÄ´ 7812 ÃÄÄÂÄÄÄÄÄ> +13.80V
RAW DC ³ ÀÄÄÄÂÄÄÄÙ ³
FROM >2200uF ³+ com³ ³
BRIDGE 30V === Multi 10k === 0.1u
RECTIFIER ³ Turn ³ ³
& 16V AC 0V >ÄÄÄÁÄÄÄÄÄÄÄÄÄÄÁÄÄÄÄÄÄÁÄÄÄÄ>
Thermal stability is good, as it is dependent on Reg + the constant current
through the R, but that will be regulator make dependent.
3/ Add a voltage offset ratio arm. The 330 & 1k pot give a zero to 4x max ratio
arm, that magnifies the regulator voltage by up to 4 times, plus any voltage
gained by adding resistance in series with the common leg.
in ÚÄÄÄÄÄÄÄ¿out
+24V>ÄÄÄÄÄÂÄÄÄÄ´ 7805 ÃÄÄÂÄÄÄÄÂÄÄÄ> +5V to +20V
RAW DC ³ ÀÄÄÄÂÄÄÄÙ ³ ³
FROM >2200uF ³+ com ³ 330ê ³
BRIDGE 30V === ³ ³ === 0.1u
RECTIFIER ³ ³ 1V ³
& 17V AC ³ ÀÄÄÄÄ>POT ³
³ ³ ³
0V >ÄÄÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÁÄÄÄÄÁÄÄÄ>
Thermal stability good, as it is dependent on Reg/multiplier ratio.
NOTES
A/ For all 3 types the input must always exceed the O/P by at least 2V so that
the regulator's drop out voltage is always exceeded. There are low drop out
types available (0.3V - 1V).
Volts
Off load 25_³ _ _ _ _ _ _ _ _ _ _ _ _
On load __³ __ Discharge __ v
Peak 23 ³ /' `-._ /' Capacitor
Mean 19 --³ / `-._ / Peak-Peak Headroom is
Min 16 __³/Charge `-._/ Ripple the voltage
³ Drop-out V ^ above Dropout
Reg O/P -³-----------------v------ X O/P ripple
13.8 ³ Unregulated
³ Dips
³
³
ÀÄÄÄÄÄÂÄÄÄÄÄÄÄÂÄÄÄÄÄÄÄÂÄÄÄ>Time
90ø 180ø 270ø Supply Phase
B/ The maximium input voltage must not exceed the regulator max (e.g. 40V)
othewise it may well go short circuit & put 40V on the Output.
C/ Many regulator types have Thermal shutdown & the current rating of 100mA,
0.5A or 1A may be limited by poor heatsinking in practice. The higher the head
room voltage the more power has to be dissipated.
D/ The metal tabs must be insulated as they are connected to the regulator
common on positive types, which in not ground! They are also the most negative
part of a regulator so for -ve types that means the -ve input!
E/ If there is a possibility that the O/P may be powered but the input not a
diode must be put output to input across the regulator to protect it.
1N4001
ÚÄÄÄÄÄÄÄ´<ÃÄÄÄÄÄÄÄ¿
³ in ÚÄÄÄÄÄÄÄ¿out ³
>ÄÄÄÄÄÄÂÄÁÄÄÄÄ´ 7805 ÃÄÄÄÄÁÄÂÄÄÄÄ> e.g. a Floated
³ ÀÄÄÄÂÄÄÄÙ ³ Battery
Why Don't U send an interesting bul?
73 De John, G8MNY @ GB7CIP
Read previous mail | Read next mail
| |
