| |
G8MNY > TECH 10.08.23 09:07l 37 Lines 1302 Bytes #999 (0) @ WW
BID : 53392_GB7CIP
Read: GUEST
Subj: Chimney Pot Sky Hook
Path: IW8PGT<LU4ECL<UA6ADV<OE6XPE<DB0ERF<DK0WUE<GB7CIP
Sent: 230810/0703Z @:GB7CIP.#32.GBR.EURO #:53392 [Caterham Surrey GBR]
From: G8MNY@GB7CIP.#32.GBR.EURO
To : TECH@WW
By G8MNY (Update Aug 23)
(8 Bit ASCII graphics use code page 437 or 850, Terminal Font)
I have used a mild steel bar 6mm x 600mm shaped like a butcher's hook, with an
insulated loop at the bottom & put into a sturdy chimney pot, to support 160m
long wire aerial going over the house.
____ Insulated
steel /.--,\ loop
±± bar Ý ±± Þ ___
±± over Ý ±± Þ//~\\ .ú'
±± top Ý ±± \\__//ú'
±± of Ý ±± ~~~~ú aerial wire
±± Pot ±± '.threaded
±± ±± ú in loop
To insulate the loop I put on 150mm of polly tubing, & over that some garden
hose pipe, before bending it in to a loop in a strong vice, & leaving just
enough gap to let the wire in.
To put it in place once the wire was threaded @ 11m up, I "loosely" taped it to
a thin light 5m pole, that went through the loop. Then using a ladder at only
gutter height aimed it at the pot. Once in place I worked the pole to free it
from the tape. When the wire broke, recovery was done with the same 5m pole
this time threaded it into the loop hole & the wire soon replaced.
See my TECH bul on "Tree Antenna Sky Hooks" & "Casting Lead Throwing Weights"
Why Don't U send an interesting bul?
73 de John G8MNY @ GB7CIP
Read previous mail | Read next mail
| |
